How are the wireframe basins assembled? With your own hands, this is done quite simply
During the summer heat the owners of any landThe plot can be pampered by swimming in the pool. At the same time, you do not need to buy an expensive finished product and invite specialists. You can build a skeleton pool with your own hands. Such pools can be installed anywhere and anytime. The main thing is that the playground is firm and perfectly level. Frame pool models are almost the most popular along with inflatables. Often, in addition to the instructions and the construction, the kit includes even the necessary equipment for installation.
Making baskets with wire frames,you must first carefully level the surface. Raise the base of the ground is dangerous. Over time, the embankment is washed away, and the pool may be damaged. It is most reliable to remove the fertile layer together with vegetation and roots and replace it with five centimeters of sifted sand. The geotextile lining will protect the pool bow from various damages.
Assembling the pool
Before installing the basin skeletonwith their own hands, on the already prepared site will need to lay geotextiles. Then open the box and lay the basin bowl over the deck. The hole intended for draining must be turned towards the water outlet. After the material is warmed by the sun, you need to insert the posts and beams into the corresponding holes. It is important to act consistently. Therefore, all installation should be done exactly according to the instructions that are attached to the pool. It is worth to know that to assemble the basin skeleton by your own hands, namely their individual modules, you can without special tools.
Final preparation of the basin
Pools for cottages are necessaryset strictly horizontally with respect to the surface of the earth. Before filling the pool with water, it is important to make sure that the structure is positioned correctly, the drain plug is tightly closed and its lid tightly twisted. If problems do not arise, then you can spread the folds and fill the container. After filling, you need to adjust the acidity of the water and disinfect it.
Assembling the basin skeleton with your own hands, notIt is worth forgetting about some specific nuances. First you need to mount the frame and paste geotextiles to it, only then the bowl is placed inside the contour. After hanging the canvas on the walls do not need to fix it over the entire area. In order to straighten the liner carefully, you need to partially fill the bowl with water. For a better fit of the fabric to the frame, it is necessary to seal the cutout under the screamer with adhesive tape and draw air through the hole. When the water rises by 15 cm, you can install a skimmer and a return nozzle. Skeleton pool is ready!
As you can see, there is nonothing terrible and complicated. Is it worth spending money on hiring special teams? But it's up to the owner of the frame pool to decide everything. However, if you decide to cope with the task yourself, then this review, no doubt, will be able to help you. Good luck in creating a place for swimming!